FS-1052: Applicable Documents

2. REFERENCED DOCUMENTS. The issues of the following documents in effect on the date of invitation for bids or request for proposal form a part of this standard to the extent specified herein.

2.1 Governmental.

Federal Standards

• FED-STD-1003 Synchronous Bit Oriented Data Link Control Procedures (Advanced Data Communications Control Procedures)
• FED-STD-1020 Telecommunications: Electrical Characteristics of Balanced Voltage Digital Interface Circuits
• FED-STD-1030 Telecommunications: Electrical Characteristics of Unbalanced Voltage Digital Interface Circuits
• FED-STD-1035 Coding, Modulation and Transmission Requirements for Single Channel Medium and High Frequency Radiotelegraph Systems Used in Government Maritime Mobile Telecommunications
• FED-STD-1037 Glossary of Telecommunication Terms
• FED-STD-1045 Telecommunications: HF Radio Automatic Link Establishment

Military standards

• MIL-STD-188-110 Interoperability and Performance Standards for Data Modems
• MIL-STD-188-115 Interoperability and Performance Standards for Communications Timing and Synchronization Subsystems
• MIL-STD-188-148 (S) Interoperability Standard for Anti-Jam (AJ) Communications in the High Frequency Band (2-30 MHz) (U)

Military specifications

• MIL-C-28883 Military Specification for the Advanced Narrowband Digital Voice Terminal (ANDVT) Tactical Terminal (TACTERM) CV-3591 and Ancillaries

(Those outside the Federal Government may obtain copies of Federal specifications and standards as stated in the Index of Federal Specifications, Standards and Commercial Item Descriptions. The Index, including cumulative supplements issued during the year, is sold on subscription by the Superintendent of Documents, U.S. Government Printing Office, Washington, D.C. 20402.)

(Single copies of Federal specifications and standards required for bidding purposes are available from the General Services Administration Business Service Centers in Boston, MA; New York, NY; Atlanta, GA; Chicago, IL; Kansas City, MO; Fort Worth, TX; Denver, CO; San Francisco, CA; Los Angeles, CA; and Seattle, WA, or from the General Services Administration Supply Distribution Facility Franconia - Building A, Loisdale Road, Franconia, VA 22105.)

(Federal Government activities may obtain copies of Federal Specifications and Standards from established distribution points in their agencies.) (Unless otherwise indicated, copies of Federal and military specifications, standards, and handbooks are available from the Naval Publications and Forms Center, (ATTN: NPODS), 5801 Tabor Avenue, Philadelphia, PA 19120-5099.)

2.2 Non-governmental.

International Standardization Documents

North Atlantic Treaty Organization (NATO) Standardization Agreements (STANAG)

• STANAG 4197 Modulation and coding characteristics that must be common to ensure interoperability of 2400 bps linear predictive encoded digital speech transmitted over HF radio facilities
• STANAG 4198 Parameter and coding characteristics that must be common to ensure interoperability of 2400 bps linear predictive encoded digital speech
• STANAG 4285 Characteristics of 1200/2400/3600 bits per second single tone modulators/demodulators for HF radio links
• STANAG 5031 Minimum standards for naval HF, MF, and LF shore-to-ship broadcast systems
• STANAG 5035 Introduction of an improved system for maritime air communications on HF, LF, and UHF

Quadripartite Standardization Agreements (QSTAG)

• QSTAG-303 Frequency shift standards for HF/RATT and VHF/RATT operation

(Application for copies should be addressed to: Standardization Document Order Desk, 700 Robbins Avenue, Building 4, Section D, Philadelphia, PA 19111.)

International Telecommunication Union (ITU)

• CCIR Radio Report 549: HF Ionospheric Regulations, Channel Simulators Volume III

(Application for copies should be addressed to the General Secretariat, International Telecommunication Union, Place des Nations, CH-1211 Geneva 20, Switzerland or the U.S. Department of Commerce, National Technical Information Service, 5285 Port Royal Road, Springfield, VA 22161.)

International Organization for Standardization (ISO)

• ISO/IEC 8886.3 Information processing systems - Data communication - Data link service definition for Open Systems Interconnection

National Standardization Documents

American National Standards Institute (ANSI)

• ANSI/EIA-232 Interface Between Data Terminal Equipment and Data Circuit-Terminating Equipment Employing Serial Binary Data Interchange
• ANSI/EIA/TIA-562 Electrical Characteristics for An Unbalanced Digital Interface
• ANSI/EIA/TIA-574 9 Position Non-Synchronous Interface Between Data Terminal Equipment and Data Circuit-Terminating Equipment Employing Serial Binary Interchange

(Applications for copies of ISO and ANSI publications should be addressed to: American National Standards Institute, 11 West 42nd Street, 13th floor, New York, NY 10036.)

Electronic Industries Association (EIA)

• EIA-423 Electrical Characteristics of Unbalanced Voltage Digital Interface Circuits

(Application for copies should be addressed to: Electronic Industries Association, Engineering Department, 2001 Pennsylvania Ave. N.W., Washington, D.C. 20006)

(Non-Government standards and other publications are normally available from the organizations that prepare or distribute the documents. These documents also may be available in or through libraries or other informational services.)

2.3 Order of precedence. In the event of a conflict between the text of this document and the references cited herein, the text of this document takes precedence. Nothing in this document, however, supersedes applicable laws and regulations unless a specific exemption has been obtained.